F10 Aft Lower Cabin Details.
F10-13 R&L Seat Belt Attach Angles.
I located and drilled the pilot holes to #40 size.
F10-08 and F10-11 Clips.
I used some left over Z03-02 .032 Channel to make these clips. I used the band saw to cut the rough dimensions. I then used the scotch brite wheel to finish to the final sizes. I marked and drilled the required pilot holes to the #40 size.
F10-10 R&L Support Channels.
I used the hack saw to cut the rough length of the Z02-04 Channel Stock. I used the band saw and files to cut out the required notches. I used the scotch brite wheel to finish to final dimensions. I marked and drilled the pilot holes to #40 size.
F10-09 R&L Support Channel Assemblies.
I clamped the F10-11 Clips to the F10-10 Channels and drilled and up drilled the required holes. I deburred and cleaned the parts. Then I revited the clips to the channels to complete the assemblies.

Click on a picture to enlarge it: