F26-08 Rudder Stop Plate.
I used the band saw to cut 2 Rudder Stop Plates from 1" x .125" stock provided with the kit. I then used the scotch brite wheel to smooth and shape the cut edges. I also used a fine sanding block to clean up and smooth all sides and edges.

F26-07 Lower Vertical Splice Plate.
The basic shaped stock was provided with the kit. I used the drill press to clean out the pilot holes. I used the arbor press to bend the parts to the 7/16" (13.6 deg) per the plans. I also used files and the scotch brite wheel to add the 1/16th inch chamfer as required per the plans. Files and the scotch brite wheel were also used to clean, polish and debur all the edges.


Click on a picture to enlarge it:

gallery thumbnail gallery thumbnail gallery thumbnail